MX-6 parting out..... probably

[eXtreMX-6]

Hey everybody, As a few of you might know im done with the MX-6 right now... I have run into to many problems and even without these problems i couldnt take this cqar to Wyoming with me for financial and clearance reasons. (the car sits to low for snow)

So i and or Mike Hughes (have many parts I am going to be selling off of it.. (I am probably trading the car to him)

Some of the part include...
KLZE engine
pheno thermal spacers
stainless steel Headers with ceramic header wrap
2.5" stainless steel Resonated test pipe
2.5" mandrel bent exhaust system with 22" Magnaflow Resonator and 4 inch muffler tip
Cross dimpled and slotted rotors
Stainless steel brake lines with KVR brake pads
Tokico Illumina 5 way adjustable strutswith Eibach Pro kit drop springs
indiglo gauges with red needles
Weapon R filter (plus i'll give you the tubing and decals that say weapon R to sell, just the filter cost $70)
65mm KL03 Throttle Body with Brass plate
Plus an extra KLZE IAC
Brand new battery with 3 year warranty (autozone)
rear sturt tower bar,
(possible MTX conversion kit),
Short Throw Shifter w/ a nice shift knob in my opinion,
Poly Motor Mounts
17" rims (already called for by Splat)
My custom headlights (would like Stelathmode to see them first)
Blitz front bumper
Hella projection foglights

Everything besides engine has less then 600 miles on it. Engine I believe is 34-38,000? Ill ask Mike Hughes



Stereo:
Alpine 7995 deck
JBL 600.1BP amp
JBL 80.4 amp
MB Quart RSC 213 5.5" components with tweeter and crossover
Eclipse Point source 6x8" coaxials with crossover
Two 10" JL W3v2's in Q'logic boxes wired in series for a 2 ohm load, the boxes come with the grills and the boxes also give you the option of having it ported or sealed.




Let me know if your interested in any parts! Thanks,
Dave

[95BlackGT]

I've been looking for a 65mm TB and a new suspension? How much do you want for the TB, Tokicos and Eibachs, shoot me a price for each individually.........:thup:

[GTcruiser33]

damn cory, i want that TB, if you dont get it i want it, also how much for the STS and will that fit a probe as well?

-Erich

[95BlackGT]

Cody, but it's ok, i'll forgive you this time....:D

[eXtreMX-6]

The TB ill let go for $115 if you are going to the cabin meet otherwise add like 8 more bucks for shipping. Also it comes with the KLO3 IAC but i have a ZE IAC if you need it. that ill let go for $25 pick up or $30 shipped.
As for the suspension i dont know for sure yet. Mike will be having the car most likely then so it will be up to him? It cost a total of like $680 for me? Rides unbelievably smooth and you dont get any wheel hop whatsoever when you have it on the 5 setting.

[95BlackGT]

I already have another spare TB so i don't need the IAC if you'd let it go for $100 without the IAC? But i spose you really dont have any use for it either.........

Well i'm definetly interested in the suspension......dunno if i'd have that kind of money tho, i'm sure you don't want to let it go for less then $450.

And yes i'll be at the cabin meet.:thup:

[eXtreMX-6]

:help: Dave :help:

Alright here's some prices and all is picked up at Mike Hughes Shop in Eagle Lake (by Mankato) or i will bring to the Cabin Meet

KLZE $1250
(reason being it has a new water pump, accessory belts, timing belt, and we might replace the oil pump and main seal bearing if needed) Believe me you wont find it cheaper shipped with all this maintenance just done to it!!! over $1900 invested

Exhaust System $500
(have over $980 into it now and it has a blocked off EGR for You KLZE people)

Suspension $500
(Eibach pro Kit, Tokico Illumina Adjustable Stuts) $492+$219=$711 shipped cheapest price found

Brakes $250
(Brembo Dimpled and Slotted Rotors with KVR Pads and Stainless Steel Brake Lines cost me $340 shipped)

65mm Throttle Body w/ Brass Plate $115
(It seals nicely because of the angled edges, I know i could get more but i need this money soon and i have it off my car already so if you want it shipped then $125)

ATX to MTX conversion kit $550
talk to Mike Hughes if Interested


Stereo
Remember all Audio has under 8 hours of playing time on them

Subs $400
Two 10" JL W3v2's in seperate Q-logic boxes
(comes with a blow all you want warranty and replace it until February 16th 2005 at Rocking Ronnies in Mankato)
Subs cost me $300 and boxes cost me $200 plus wiring and terminals was like $530 total after taxes

Eclipse Point Source Speakers 6X8's $120
(cost me $210 shipped)

MB Quart Components 5.5" $80
(cost me $140 shipped)

JBL BP600.1 amp $140
(cost me $210 shipped)

JBL 80.4 amp $120
(cost me $180 shipped)

Alpine 7995 deck $250
(plays MP3's, has no internal amp for sound quality reasons and is the best deck ive ever owned! Ive had Kenwood, Clarion, JVC, Pioneer, and Panasonics before.)
(This cost me $419.00 shipped)


Remember all Audio has under 8 hours of playing time on them

[Shrep]

how much for the filter?

[GTcruiser33]

Originally posted by 95BlackGT
Cody, but it's ok, i'll forgive you this time....:D

my bad, musta been in a hurry

[95BlackGT]

I'll take the TB. I'll be at the cabin meet so you can bring it there!

How much would you sell just the struts for? Thats a good deal for the suspension but i don't think i'd have enough money for the whole works?

But yeah i definetly want the TB.....where did you have the TB bored?

[Shrep]

hmmm...how much would you want for the car? the whole thing?

[eXtreMX-6]

the whole car as is? Without the stereo I'll do $4500 (I'll leave the MB Quarts in the door for you though) The car is in Primer and you can probably just paint it any color you want but i was going to be doing the Mazda paintcode 27B (Winning Blue)off of the 2004 Mazda RX-8's. I'll leave the MB Quarts in the door for you though. The car still runs right now but the oil pressure light comes on after about 10 minutes of running and only at idle so i parked it. I was going to have Mike Hughes fix it but i am low on funds enough as it is. So let me know,
Thanks,
Dave



Oh yeah and Tech Tool did an elliptical Bore and polish on the TB, I also had him make 20 elliptical brass plates to sell which i sold all of them on MX6.com. He also angled each mating surface so closure is unbelievable. He has done many custom carburator's for racing and other engine work too. He did a great job on this throttle body. It is off the car for i have the JDM one on currently.


I would rather keep the suspension all together but if you can find someone that want the eibach springs ill break them apart for you.

[95BlackGT]

Alright well i'll take it, bring it to the cabin meet.

Why do you have the other TB on there? You haven't gotten much use out of it then?

[eXtreMX-6]

The reason i have the other throttle body on this car is because when Mike switched over the engines he didnt put my bored out one on Since it was a full Jspec engine and the Throttle Body is for a KL03.. I have a ZE IAC also but we never bothered putting it on due to time issues since he was goign on vacation for a week. We barely even got the car streetable...
this throttle body has probably about 150 miles on it?

Anyways,
If someone would like to buy the entire car off of this website i am giving a big discount ($2,000) if you want the car as is right now.. I have had a lot of compliments with the car even in its primer right now. It is a big loss for me but I just need to get rid of it quick.
Someone please help me out :(
Thanks,
Dave

[Shrep]

just so im clear...

$2000 gets the car as it sits?

or

$2500 gets the car ($4500-$2000 disc)

or

$4500 is the discounted price (asking $6500 elsewhere)

Sorry...im confused
LOL

[eXtreMX-6]

Yeah i was asking $6,500 from MX6.com but i would liek to get $4,500

I cant let the car go for much cheaper. I could part it out and make more money then $4,500....


The car right nows has Buddy Club Side Skirts and Buddy Club Rear bumper all molded on right now. And the Blitz front bumper not molded on. The Rain seam at the top is molded and it has z3 fenders molded in. The car is in all primer right now and it runs and drives. If you want the stereo included $5,400...

Thanks,
Dave
aka Shortbus

[eXtreMX-6]

Plus if you buy the car as a whole you get the rims which if you dont want you can sell them to Splat since he wants them really bad. So your really getting a heck of a deal in my honest opinion,

Fully kitted car,
KLZE,
Suspension,
Brakes,
Full exhaust sytem,
Dynamatted trunk,
Shaved emblems, keyhole, and antenna,
detailed interior and engine bay...
and more..

[BlackStormInc]

I didn't bother looking and/or reading the whole thread here so i'll just ask ...

From the MX6, do you have a transmission that works great that will fit a V6 5-speed probe?

- BlackStorm

[eXtreMX-6]

The Tranny will be sold as an entire MTX conversion kit. sorry...

[eXtreMX-6]

If anybody wants parts you can shoot me some offers.. No decent offers will be denied! I will be strippign down the car this next week. Also I will be bringing me headlights (for stelathmode to see) and some other little parts to sell at the Cabin meet if i can get myself there some how?

[wannabfast]

i need a new radio for my audi.. its got an old school tape deck.. the kind where you can pull the ENTIRE radio out.. as opposed to just the face

[eXtreMX-6]

My deck needs an external amplifier which i have but i wouldnt recommend mine unless your looking to hook it up to a pretty nice stereo... stock it wouldnt be worth it.
I might have my deck and 4 channel amp already sold but no one has bought it yet for sure so if you still want it let me know.
Dave

[eXtreMX-6]

Also does anybody want some KLZE Parts?
Pistons,
Cams,
Intake Manifold,
Throttle Body,
Heads?

I also will have the Poly Motor Mounts which were also filled with Polyurethane. So they are solid Poly mounts now :D


The Intake Manifold and front Valve Cover have a Gloss Black with metallic flake silver fade paint job and the MAZDA is polished. The Valve Cover also comes with a Mazdaspeed Oil Cap.

Shoot me some offers!

[95BlackGT]

Looks like i'm not gonna be making it to the meet dave, so i won't be getting the 65mm TB from you anymore. It's all yours if you want it Eric.

[GTcruiser33]

how much did you want for that 65 mm TB agian? thanks

[Shrep]

I'll take the rear calipers and e-brake cable. (for the right price of course)

[eXtreMX-6]

Originally stupidified by Shrep
I'll take the rear calipers and e-brake cable. (for the right price of course)

Rear Calipers are the anodized blue paint on them. SO i dunno if youd want them or to just get some from Mike Hughes? I'll let you know more when i start ripping everything apart :D



Originally did by GTcruiser33
how much did you want for that 65 mm TB agian? thanks


115 picked up or 125 shipped but it is sale pending for $145 shipped on MX6.com ill let you know if he goes through or not.

[GTcruiser33]

[i]
115 picked up or 125 shipped but it is sale pending for $145 shipped on MX6.com ill let you know if he goes through or not. [/B]

ok, thanks

[Shrep]

I'll likely take them, and just repaint them.

let me know.

Mike Houghes is too busy to worry about calipers LOL

[eXtreMX-6]

All parts have been listed on MX6.com now so PM if you need anything off it asap or they will be sold really quickly now because im also gonna put it on probetalk to get it sold.

[Shrep]

pm sent...seems a little odd to habve to do...but it's sent anyways.